Super-systems HP2000 With 9100 Controller Manual de usuario

Operations ManualHP2000With 9100 ControllerSelf-Heated OxygenMeasurement SystemPlease read, understand, and follow these instructions before operating

Spare Parts List• CeraGold Probe with “S” T/C Part Number 10138• Sample Pump Part Number 37134• 110VAC Heater Part Number 32074• Large Bowl Filer

Electrical ConnectionsRemove the screw cover on the electrical enclosure box on the side of the main box. Route thegreen “S” Type thermocouple wire a

Once the probe has been inserted into the heater, make the necessary electrical connections at thehead of the probe. The green thermocouple wire from

Entering Values Through the KeypadOnly numeric values may be entered into the HP2000 display. The up arrow will cycle throughthe numbers starting with

Screen 1: Oxygen (in %), Probe mV and Probe TemperatureThis screen is the default screen for the HP2000. This screen lists the percentage of oxygen o

This screen will display the temperature set point for the HP2000, and it will allow the user tomodify the temperature set point for the HP2000. The H

This screen will display the temperature mode and it will also allow the user to change thetemperature mode. The temperature mode can be either Fahre

The Output 1 Exponent provides greater detail for the output. The valid range of values is zeroto ten. To change the value, press the up arrow key o

The valid range of values for output 2 full scale is zero to nine thousand nine hundred ninetynine. To change the value, press the up arrow key once